| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
net: stmmac: Correctly handle Rx checksum offload errors
The stmmac_rx function would previously set skb->ip_summed to
CHECKSUM_UNNECESSARY if hardware checksum offload (CoE) was enabled
and the packet was of a known IP ethertype.
However, this logic failed to check if the hardware had actually
reported a checksum error. The hardware status, indicating a header or
payload checksum failure, was being ignored at this stage. This could
cause corrupt packets to be passed up the network stack as valid.
This patch corrects the logic by checking the `csum_none` status flag,
which is set when the hardware reports a checksum error. If this flag
is set, skb->ip_summed is now correctly set to CHECKSUM_NONE,
ensuring the kernel's network stack will perform its own validation and
properly handle the corrupt packet. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/xe: Fix oops in xe_gem_fault when running core_hotunplug test.
I saw an oops in xe_gem_fault when running the xe-fast-feedback
testlist against the realtime kernel without debug options enabled.
The panic happens after core_hotunplug unbind-rebind finishes.
Presumably what happens is that a process mmaps, unlocks because
of the FAULT_FLAG_RETRY_NOWAIT logic, has no process memory left,
causing ttm_bo_vm_dummy_page() to return VM_FAULT_NOPAGE, since
there was nothing left to populate, and then oopses in
"mem_type_is_vram(tbo->resource->mem_type)" because tbo->resource
is NULL.
It's convoluted, but fits the data and explains the oops after
the test exits. |
| In the Linux kernel, the following vulnerability has been resolved:
nvmet-fc: avoid scheduling association deletion twice
When forcefully shutting down a port via the configfs interface,
nvmet_port_subsys_drop_link() first calls nvmet_port_del_ctrls() and
then nvmet_disable_port(). Both functions will eventually schedule all
remaining associations for deletion.
The current implementation checks whether an association is about to be
removed, but only after the work item has already been scheduled. As a
result, it is possible for the first scheduled work item to free all
resources, and then for the same work item to be scheduled again for
deletion.
Because the association list is an RCU list, it is not possible to take
a lock and remove the list entry directly, so it cannot be looked up
again. Instead, a flag (terminating) must be used to determine whether
the association is already in the process of being deleted. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: Intel: avs: Disable periods-elapsed work when closing PCM
avs_dai_fe_shutdown() handles the shutdown procedure for HOST HDAudio
stream while period-elapsed work services its IRQs. As the former
frees the DAI's private context, these two operations shall be
synchronized to avoid slab-use-after-free or worse errors. |
| In the Linux kernel, the following vulnerability has been resolved:
serial: qcom-geni: Fix blocked task
Revert commit 1afa70632c39 ("serial: qcom-geni: Enable PM runtime for
serial driver") and its dependent commit 86fa39dd6fb7 ("serial:
qcom-geni: Enable Serial on SA8255p Qualcomm platforms") because the
first one causes regression - hang task on Qualcomm RB1 board (QRB2210)
and unable to use serial at all during normal boot:
INFO: task kworker/u16:0:12 blocked for more than 42 seconds.
Not tainted 6.17.0-rc1-00004-g53e760d89498 #9
"echo 0 > /proc/sys/kernel/hung_task_timeout_secs" disables this message.
task:kworker/u16:0 state:D stack:0 pid:12 tgid:12 ppid:2 task_flags:0x4208060 flags:0x00000010
Workqueue: async async_run_entry_fn
Call trace:
__switch_to+0xe8/0x1a0 (T)
__schedule+0x290/0x7c0
schedule+0x34/0x118
rpm_resume+0x14c/0x66c
rpm_resume+0x2a4/0x66c
rpm_resume+0x2a4/0x66c
rpm_resume+0x2a4/0x66c
__pm_runtime_resume+0x50/0x9c
__driver_probe_device+0x58/0x120
driver_probe_device+0x3c/0x154
__driver_attach_async_helper+0x4c/0xc0
async_run_entry_fn+0x34/0xe0
process_one_work+0x148/0x290
worker_thread+0x2c4/0x3e0
kthread+0x118/0x1c0
ret_from_fork+0x10/0x20
The issue was reported on 12th of August and was ignored by author of
commits introducing issue for two weeks. Only after complaining author
produced a fix which did not work, so if original commits cannot be
reliably fixed for 5 weeks, they obviously are buggy and need to be
dropped. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: storage: sddr55: Reject out-of-bound new_pba
Discovered by Atuin - Automated Vulnerability Discovery Engine.
new_pba comes from the status packet returned after each write.
A bogus device could report values beyond the block count derived
from info->capacity, letting the driver walk off the end of
pba_to_lba[] and corrupt heap memory.
Reject PBAs that exceed the computed block count and fail the
transfer so we avoid touching out-of-range mapping entries. |
| In the Linux kernel, the following vulnerability has been resolved:
smc: Use __sk_dst_get() and dst_dev_rcu() in smc_clc_prfx_match().
smc_clc_prfx_match() is called from smc_listen_work() and
not under RCU nor RTNL.
Using sk_dst_get(sk)->dev could trigger UAF.
Let's use __sk_dst_get() and dst_dev_rcu().
Note that the returned value of smc_clc_prfx_match() is not
used in the caller. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: firewire-motu: fix buffer overflow in hwdep read for DSP events
The DSP event handling code in hwdep_read() could write more bytes to
the user buffer than requested, when a user provides a buffer smaller
than the event header size (8 bytes).
Fix by using min_t() to clamp the copy size, This ensures we never copy
more than the user requested. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_event: validate skb length for unknown CC opcode
In hci_cmd_complete_evt(), if the command complete event has an unknown
opcode, we assume the first byte of the remaining skb->data contains the
return status. However, parameter data has previously been pulled in
hci_event_func(), which may leave the skb empty. If so, using skb->data[0]
for the return status uses un-init memory.
The fix is to check skb->len before using skb->data. |
| In the Linux kernel, the following vulnerability has been resolved:
gve: Implement gettimex64 with -EOPNOTSUPP
gve implemented a ptp_clock for sole use of do_aux_work at this time.
ptp_clock_gettime() and ptp_sys_offset() assume every ptp_clock has
implemented either gettimex64 or gettime64. Stub gettimex64 and return
-EOPNOTSUPP to prevent NULL dereferencing. |
| In the Linux kernel, the following vulnerability has been resolved:
gve: Implement settime64 with -EOPNOTSUPP
ptp_clock_settime() assumes every ptp_clock has implemented settime64().
Stub it with -EOPNOTSUPP to prevent a NULL dereference. |
| In the Linux kernel, the following vulnerability has been resolved:
net: bridge: fix use-after-free due to MST port state bypass
syzbot reported[1] a use-after-free when deleting an expired fdb. It is
due to a race condition between learning still happening and a port being
deleted, after all its fdbs have been flushed. The port's state has been
toggled to disabled so no learning should happen at that time, but if we
have MST enabled, it will bypass the port's state, that together with VLAN
filtering disabled can lead to fdb learning at a time when it shouldn't
happen while the port is being deleted. VLAN filtering must be disabled
because we flush the port VLANs when it's being deleted which will stop
learning. This fix adds a check for the port's vlan group which is
initialized to NULL when the port is getting deleted, that avoids the port
state bypass. When MST is enabled there would be a minimal new overhead
in the fast-path because the port's vlan group pointer is cache-hot.
[1] https://syzkaller.appspot.com/bug?extid=dd280197f0f7ab3917be |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: xattr: fix null pointer deref in ext4_raw_inode()
If ext4_get_inode_loc() fails (e.g. if it returns -EFSCORRUPTED),
iloc.bh will remain set to NULL. Since ext4_xattr_inode_dec_ref_all()
lacks error checking, this will lead to a null pointer dereference
in ext4_raw_inode(), called right after ext4_get_inode_loc().
Found by Linux Verification Center (linuxtesting.org) with SVACE. |
| In the Linux kernel, the following vulnerability has been resolved:
platform/x86: int3472: Fix double free of GPIO device during unregister
regulator_unregister() already frees the associated GPIO device. On
ThinkPad X9 (Lunar Lake), this causes a double free issue that leads to
random failures when other drivers (typically Intel THC) attempt to
allocate interrupts. The root cause is that the reference count of the
pinctrl_intel_platform module unexpectedly drops to zero when this
driver defers its probe.
This behavior can also be reproduced by unloading the module directly.
Fix the issue by removing the redundant release of the GPIO device
during regulator unregistration. |
| In the Linux kernel, the following vulnerability has been resolved:
exfat: fix improper check of dentry.stream.valid_size
We found an infinite loop bug in the exFAT file system that can lead to a
Denial-of-Service (DoS) condition. When a dentry in an exFAT filesystem is
malformed, the following system calls — SYS_openat, SYS_ftruncate, and
SYS_pwrite64 — can cause the kernel to hang.
Root cause analysis shows that the size validation code in exfat_find()
does not check whether dentry.stream.valid_size is negative. As a result,
the system calls mentioned above can succeed and eventually trigger the DoS
issue.
This patch adds a check for negative dentry.stream.valid_size to prevent
this vulnerability. |
| In the Linux kernel, the following vulnerability has been resolved:
ocfs2: fix double free in user_cluster_connect()
user_cluster_disconnect() frees "conn->cc_private" which is "lc" but then
the error handling frees "lc" a second time. Set "lc" to NULL on this
path to avoid a double free. |
| In the Linux kernel, the following vulnerability has been resolved:
fs: jfs: fix shift-out-of-bounds in dbAllocAG
Syzbot found a crash : UBSAN: shift-out-of-bounds in dbAllocAG. The
underlying bug is the missing check of bmp->db_agl2size. The field can
be greater than 64 and trigger the shift-out-of-bounds.
Fix this bug by adding a check of bmp->db_agl2size in dbMount since this
field is used in many following functions. The upper bound for this
field is L2MAXL2SIZE - L2MAXAG, thanks for the help of Dave Kleikamp.
Note that, for maintenance, I reorganized error handling code of dbMount. |
| In the Linux kernel, the following vulnerability has been resolved:
net/sctp: fix a null dereference in sctp_disposition sctp_sf_do_5_1D_ce()
If new_asoc->peer.adaptation_ind=0 and sctp_ulpevent_make_authkey=0
and sctp_ulpevent_make_authkey() returns 0, then the variable
ai_ev remains zero and the zero will be dereferenced
in the sctp_ulpevent_free() function. |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: verify orphan file size is not too big
In principle orphan file can be arbitrarily large. However orphan replay
needs to traverse it all and we also pin all its buffers in memory. Thus
filesystems with absurdly large orphan files can lead to big amounts of
memory consumed. Limit orphan file size to a sane value and also use
kvmalloc() for allocating array of block descriptor structures to avoid
large order allocations for sane but large orphan files. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: arm64: Check the untrusted offset in FF-A memory share
Verify the offset to prevent OOB access in the hypervisor
FF-A buffer in case an untrusted large enough value
[U32_MAX - sizeof(struct ffa_composite_mem_region) + 1, U32_MAX]
is set from the host kernel. |
