| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
clk: visconti: Fix memory leak in visconti_register_pll()
@pll->rate_table has allocated memory by kmemdup(), if clk_hw_register()
fails, it should be freed, otherwise it will cause memory leak issue,
this patch fixes it. |
| A vulnerability in the Internet Key Exchange Version 2 (IKEv2) feature of Cisco IOS Software, IOS XE Software, Secure Firewall Adaptive Security Appliance (ASA) Software, and Secure Firewall Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a memory leak, resulting in a denial of service (DoS) condition.
This vulnerability is due to a lack of proper processing of IKEv2 packets. An attacker could exploit this vulnerability by sending crafted IKEv2 packets to an affected device. In the case of Cisco IOS and IOS XE Software, a successful exploit could allow the attacker to cause the device to reload unexpectedly. In the case of Cisco ASA and FTD Software, a successful exploit could allow the attacker to partially exhaust system memory, causing system instability such as being unable to establish new IKEv2 VPN sessions. A manual reboot of the device is required to recover from this condition. |
| In the Linux kernel, the following vulnerability has been resolved:
net: fix stack overflow when LRO is disabled for virtual interfaces
When the virtual interface's feature is updated, it synchronizes the
updated feature for its own lower interface.
This propagation logic should be worked as the iteration, not recursively.
But it works recursively due to the netdev notification unexpectedly.
This problem occurs when it disables LRO only for the team and bonding
interface type.
team0
|
+------+------+-----+-----+
| | | | |
team1 team2 team3 ... team200
If team0's LRO feature is updated, it generates the NETDEV_FEAT_CHANGE
event to its own lower interfaces(team1 ~ team200).
It is worked by netdev_sync_lower_features().
So, the NETDEV_FEAT_CHANGE notification logic of each lower interface
work iteratively.
But generated NETDEV_FEAT_CHANGE event is also sent to the upper
interface too.
upper interface(team0) generates the NETDEV_FEAT_CHANGE event for its own
lower interfaces again.
lower and upper interfaces receive this event and generate this
event again and again.
So, the stack overflow occurs.
But it is not the infinite loop issue.
Because the netdev_sync_lower_features() updates features before
generating the NETDEV_FEAT_CHANGE event.
Already synchronized lower interfaces skip notification logic.
So, it is just the problem that iteration logic is changed to the
recursive unexpectedly due to the notification mechanism.
Reproducer:
ip link add team0 type team
ethtool -K team0 lro on
for i in {1..200}
do
ip link add team$i master team0 type team
ethtool -K team$i lro on
done
ethtool -K team0 lro off
In order to fix it, the notifier_ctx member of bonding/team is introduced. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: qla2xxx: Check valid rport returned by fc_bsg_to_rport()
Klocwork reported warning of rport maybe NULL and will be dereferenced.
rport returned by call to fc_bsg_to_rport() could be NULL and dereferenced.
Check valid rport returned by fc_bsg_to_rport(). |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7921e: fix rmmod crash in driver reload test
In insmod/rmmod stress test, the following crash dump shows up immediately.
The problem is caused by missing mt76_dev in mt7921_pci_remove(). We
should make sure the drvdata is ready before probe() finished.
[168.862789] ==================================================================
[168.862797] BUG: KASAN: user-memory-access in try_to_grab_pending+0x59/0x480
[168.862805] Write of size 8 at addr 0000000000006df0 by task rmmod/5361
[168.862812] CPU: 7 PID: 5361 Comm: rmmod Tainted: G OE 5.19.0-rc6 #1
[168.862816] Hardware name: Intel(R) Client Systems NUC8i7BEH/NUC8BEB, 05/04/2020
[168.862820] Call Trace:
[168.862822] <TASK>
[168.862825] dump_stack_lvl+0x49/0x63
[168.862832] print_report.cold+0x493/0x6b7
[168.862845] kasan_report+0xa7/0x120
[168.862857] kasan_check_range+0x163/0x200
[168.862861] __kasan_check_write+0x14/0x20
[168.862866] try_to_grab_pending+0x59/0x480
[168.862870] __cancel_work_timer+0xbb/0x340
[168.862898] cancel_work_sync+0x10/0x20
[168.862902] mt7921_pci_remove+0x61/0x1c0 [mt7921e]
[168.862909] pci_device_remove+0xa3/0x1d0
[168.862914] device_remove+0xc4/0x170
[168.862920] device_release_driver_internal+0x163/0x300
[168.862925] driver_detach+0xc7/0x1a0
[168.862930] bus_remove_driver+0xeb/0x2d0
[168.862935] driver_unregister+0x71/0xb0
[168.862939] pci_unregister_driver+0x30/0x230
[168.862944] mt7921_pci_driver_exit+0x10/0x1b [mt7921e]
[168.862949] __x64_sys_delete_module+0x2f9/0x4b0
[168.862968] do_syscall_64+0x38/0x90
[168.862973] entry_SYSCALL_64_after_hwframe+0x63/0xcd
Test steps:
1. insmode
2. do not ifup
3. rmmod quickly (within 1 second) |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: ath12k: Fix memory leak in rx_desc and tx_desc
Currently when ath12k_dp_cc_desc_init() is called we allocate
memory to rx_descs and tx_descs. In ath12k_dp_cc_cleanup(), during
descriptor cleanup rx_descs and tx_descs memory is not freed.
This is cause of memory leak. These allocated memory should be
freed in ath12k_dp_cc_cleanup.
In ath12k_dp_cc_desc_init(), we can save base address of rx_descs
and tx_descs. In ath12k_dp_cc_cleanup(), we can free rx_descs and
tx_descs memory using their base address.
Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1 |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: fix pci device refcount leak
As comment of pci_get_domain_bus_and_slot() says, it returns
a pci device with refcount increment, when finish using it,
the caller must decrement the reference count by calling
pci_dev_put().
So before returning from amdgpu_device_resume|suspend_display_audio(),
pci_dev_put() is called to avoid refcount leak. |
| In the Linux kernel, the following vulnerability has been resolved:
x86/apic: Don't disable x2APIC if locked
The APIC supports two modes, legacy APIC (or xAPIC), and Extended APIC
(or x2APIC). X2APIC mode is mostly compatible with legacy APIC, but
it disables the memory-mapped APIC interface in favor of one that uses
MSRs. The APIC mode is controlled by the EXT bit in the APIC MSR.
The MMIO/xAPIC interface has some problems, most notably the APIC LEAK
[1]. This bug allows an attacker to use the APIC MMIO interface to
extract data from the SGX enclave.
Introduce support for a new feature that will allow the BIOS to lock
the APIC in x2APIC mode. If the APIC is locked in x2APIC mode and the
kernel tries to disable the APIC or revert to legacy APIC mode a GP
fault will occur.
Introduce support for a new MSR (IA32_XAPIC_DISABLE_STATUS) and handle
the new locked mode when the LEGACY_XAPIC_DISABLED bit is set by
preventing the kernel from trying to disable the x2APIC.
On platforms with the IA32_XAPIC_DISABLE_STATUS MSR, if SGX or TDX are
enabled the LEGACY_XAPIC_DISABLED will be set by the BIOS. If
legacy APIC is required, then it SGX and TDX need to be disabled in the
BIOS.
[1]: https://aepicleak.com/aepicleak.pdf |
| The Apollo Router Core is a configurable, high-performance graph router written in Rust to run a federated supergraph that uses Apollo Federation 2. A vulnerability in Apollo Router allowed queries with deeply nested and reused named fragments to be prohibitively expensive to query plan, specifically due to internal optimizations being frequently bypassed. The query planner includes an optimization that significantly speeds up planning for applicable GraphQL selections. However, queries with deeply nested and reused named fragments can generate many selections where this optimization does not apply, leading to significantly longer planning times. Because the query planner does not enforce a timeout, a small number of such queries can exhaust router's thread pool, rendering it inoperable. This could lead to excessive resource consumption and denial of service. This has been remediated in apollo-router versions 1.61.2 and 2.1.1. |
| In the Linux kernel, the following vulnerability has been resolved:
dmaengine: qcom-adm: fix wrong calling convention for prep_slave_sg
The calling convention for pre_slave_sg is to return NULL on error and
provide an error log to the system. Qcom-adm instead provide error
pointer when an error occur. This indirectly cause kernel panic for
example for the nandc driver that checks only if the pointer returned by
device_prep_slave_sg is not NULL. Returning an error pointer makes nandc
think the device_prep_slave_sg function correctly completed and makes
the kernel panics later in the code.
While nandc is the one that makes the kernel crash, it was pointed out
that the real problem is qcom-adm not following calling convention for
that function.
To fix this, drop returning error pointer and return NULL with an error
log. |
| In the Linux kernel, the following vulnerability has been resolved:
media: ipu3-imgu: Fix NULL pointer dereference in active selection access
What the IMGU driver did was that it first acquired the pointers to active
and try V4L2 subdev state, and only then figured out which one to use.
The problem with that approach and a later patch (see Fixes: tag) is that
as sd_state argument to v4l2_subdev_get_try_crop() et al is NULL, there is
now an attempt to dereference that.
Fix this.
Also rewrap lines a little. |
| An authentication bypass vulnerability can allow a low privileged attacker to access the NTLM hash of service account on the VSPC server. |
| Improper Control of Filename for Include/Require Statement in PHP Program ('PHP Remote File Inclusion') vulnerability in Majestic Support Majestic Support majestic-support allows PHP Local File Inclusion.This issue affects Majestic Support: from n/a through <= 1.0.7. |
| Multiple CWE-78 |
| In the Linux kernel, the following vulnerability has been resolved:
bnxt_en: fix memory leak in bnxt_nvm_test()
Free the kzalloc'ed buffer before returning in the success path. |
| Improper Neutralization of Input During Web Page Generation ('Cross-site Scripting') vulnerability in StylemixThemes Consulting Elementor Widgets consulting-elementor-widgets allows DOM-Based XSS.This issue affects Consulting Elementor Widgets: from n/a through <= 1.4.2. |
| SAP MDM Server allows an attacker to gain control of existing client sessions and execute certain functions without having to re-authenticate giving the ability to access or modify non-sensitive information or consume sufficient resources which could degrade the performance of the server causing low impact on confidentiality, integrity and availibility of the application. |
| Use of Default Cryptographic Key (CWE-1394) |
| Pion Interceptor is a framework for building RTP/RTCP communication software. Versions v0.1.36 through v0.1.38 contain a bug in a RTP packet factory that can be exploited to trigger a panic with Pion based SFU via crafted RTP packets, This only affect users that use pion/interceptor. Users should upgrade to v0.1.39 or later, which validates that: `padLen > 0 && padLen <= payloadLength` and return error on overflow, avoiding panic. If upgrading is not possible, apply the patch from the pull request manually or drop packets whose P-bit is set but whose padLen is zero or larger than the remaining payload. |
| CWE-328: Use of Weak Hash |
